Cannot Offset Component in the Vectric Software

Overview

This video demonstrates what happens when you attempt to use the Offset Component function in Vectric Aspire without any visible components selected or available. The software displays an error message to remind you that at least one component must be visible for the offset to be applied.

Steps

1. Attempt to run the Offset Component command.
2. When no components are visible, the software will not perform the operation.
3. An error message appears, stating that you should have one or more components visible to apply the offset.

Key Points / Warnings

• Offset requires at least one visible component on the screen.
• If nothing is available for the function to act on, the command is blocked and an error is shown.
• Make a component visible (or add one) before using Offset Component to avoid the error.