Cannot Add Draft Error Message in the Vectric Software

Overview

This video explains the “Cannot Add Draft” error message in Vectric Aspire. The error occurs when there are no components or models available to receive a draft operation. The fix is straightforward: create a component or model, then apply the draft.

Steps

1. Add or create a component or model in the project.
2. Apply the draft operation to the component or model.

Key Points / Warnings

• The error appears when the software finds no components to apply a draft to.
• The draft will be applied to all visible components in the 3D view — make sure only the intended component is visible before applying.
• This error is a simple missing-data situation, not a software failure.